Product Categories


Mobile/Whatsapp:+86-13912192072


Skype:Charles_lin119


 

Home > News > Content
Flatwork Ironer According To Structure
- Sep 30, 2017 -

Flatwork Ironer According to structure

According to structureFlat ironing machine is an important washing equipment for hotels, hotels, hospitals, schools, washing factories, washing machines, washing machines and other washing machines, according to the structure is divided into single roll flat ironing machine, Ironing machine, three-roll flat ironing machine; industrial flat ironing machine according to the heating method is divided into steam heating and electric heating two, through the inverter speed to make it, flat ironing machine drum to a certain temperature, When the wet clothing is rolled between the two rollers, you can remove a lot of water, and to achieve the effect of ironing, steam heating flat ironing machine in use must pay attention to the following matters.

Steam heating flat ironing machine Note:

1, before ironing the fabric, the first flat ironing machine drum surface clean, and then a soft cloth on the surface of the drum and the machine wipe clean, to ensure that the equipment clean.

2, ironing machine work process, should always pay attention to observe whether the rotary joint leakage steam phenomenon, there are to replace the graphite ring and seal ring. Tai Feng washing machinery to remind the majority of users Note that usually in the replacement of graphite ring, the steam will have a small amount of leakage, but in the ironing machine for some time, the graphite ring by grinding, steam leakage will automatically disappear. If the steam leakage phenomenon does not disappear, you should replace the rotary joint.

3, flat ironing machine for steam, when the steam reaches the specified pressure, open the bypass pipe bypass valve, the condensate discharged into the sewer until the steam out, and then close the valve.

4, steam heating flat ironing machine should first open the trap next to the steam valve, then open the steam into the steam valve, to be empty after the water left off; then open the inverter controller, slowly turn its knob , To 2-3m / min low-speed operation of the flat ironing machine, while the inlet valve is fully open, heating the drum, observe the flat iron machine on the left side of the box on the pressure value, to be more than 0.3MPa steam pressure Can start ironing work.

5, the staff get off work, be sure to turn off the flat ironing machine power supply, so that both can guarantee the safety of the ironing machine ironing machine, but also make the flat ironing machine completely rest, such as the power did not close, the laundry equipment in standby State, this will shorten the life of the laundry equipment, while leaving security risks. Ironing procedures - mouth cloth, pillowcase 1. Preparation:

Will wash, bake a good mouth cloth, pillowcases according to the provisions of the stack, pillowcase to smooth the opening, and the opening to be consistent, and adjust the machine speed, mouth cloth 10 m / min, pillowcase 12 m / min.

2. ironing:

The pillow or mouth cloth four corners flattened, wiped into the conveyor belt, his hands to quickly finishing, to both sides of the wiping, pay attention to observe the ironing of the linen whether the phenomenon of wrinkles, to play wax cloth, found a smear , Broken, and should be promptly removed, fold the corner to show the re-wash, fold the two corners for the reported loss.

3. Interface cloth, pillowcase

Check the release of the cloth or pillowcase quality, requiring ironing, hot dry, no wrinkles, mouth cloth sizing moderate, will be washed, reported loss of the individual placed, folded when the cloth cloth 100 stacks, pillowcases 4 A stack of stacks, and 25 stacks of 100 shelves, and finally the number of accurate records.